SV1DZL-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1DZL-9. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1774366206	347 Count	772 Count	303 Count
1774364400	330 Count	745 Count	287 Count
1774362594	311 Count	713 Count	269 Count
1774360792	298 Count	683 Count	257 Count
1774358987	287 Count	657 Count	247 Count
1774357184	275 Count	638 Count	236 Count
1774355387	269 Count	620 Count	231 Count
1774353576	254 Count	595 Count	217 Count
1774351772	245 Count	582 Count	209 Count
1774348165	215 Count	531 Count	183 Count
1774347119	210 Count	531 Count	183 Count
1774345315	183 Count	458 Count	157 Count
1774344539	178 Count	458 Count	157 Count
1774342735	157 Count	410 Count	137 Count
1774340977	132 Count	354 Count	117 Count
1774339173	114 Count	318 Count	100 Count
1774337369	105 Count	282 Count	92 Count
1774335565	93 Count	253 Count	81 Count
1774333762	86 Count	223 Count	75 Count
1774331958	74 Count	181 Count	64 Count
1774330155	64 Count	148 Count	55 Count
1774328359	54 Count	124 Count	46 Count
1774326547	44 Count	101 Count	37 Count
1774324743	34 Count	77 Count	28 Count
1774322939	23 Count	51 Count	18 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)