SR8RZE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8RZE-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1784656841	151 Count	945 Count	92 Count
1784656659	147 Count	942 Count	92 Count
1784655654	136 Count	914 Count	87 Count
1784489305	199 Count	20 Count	20 Count
1784478531	189 Count	20 Count	20 Count
1784476731	188 Count	20 Count	20 Count
1784474930	187 Count	20 Count	20 Count
1784473129	186 Count	20 Count	20 Count
1784471329	185 Count	20 Count	20 Count
1784469528	184 Count	20 Count	20 Count
1784467728	183 Count	20 Count	20 Count
1784465927	182 Count	20 Count	20 Count
1784464127	181 Count	20 Count	20 Count
1784462327	180 Count	20 Count	20 Count
1784460526	163 Count	4 Count	4 Count
1784458726	162 Count	4 Count	4 Count
1784454601	144 Count	4 Count	4 Count
1784449399	129 Count	0 Count	0 Count
1784447598	128 Count	0 Count	0 Count
1784445796	127 Count	0 Count	0 Count
1784443996	126 Count	0 Count	0 Count
1784438595	123 Count	0 Count	0 Count
1784436793	122 Count	0 Count	0 Count
1784434993	121 Count	0 Count	0 Count
1784431658	115 Count	0 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)