YD2CLX-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YD2CLX-14. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	CO2*	RSSI*
1788625540	450 ppm	104 dBm
1788625239	450 ppm	104 dBm
1788624939	450 ppm	104 dBm
1788624640	450 ppm	104 dBm
1788624340	450 ppm	104 dBm
1788624039	450 ppm	104 dBm
1788623740	450 ppm	104 dBm
1788623439	450 ppm	104 dBm
1788623140	450 ppm	104 dBm
1788622840	450 ppm	104 dBm
1788622540	450 ppm	104 dBm
1788622240	450 ppm	104 dBm
1788621939	450 ppm	104 dBm
1788621640	450 ppm	104 dBm
1788621340	450 ppm	104 dBm
1788621041	450 ppm	104 dBm
1788620740	450 ppm	104 dBm
1788620439	450 ppm	104 dBm
1788620139	450 ppm	104 dBm
1788619840	450 ppm	104 dBm
1788619539	450 ppm	104 dBm
1788619240	450 ppm	104 dBm
1788618940	450 ppm	104 dBm
1788618640	450 ppm	104 dBm
1788618340	450 ppm	104 dBm

*Used Equation Coefficients:

CO2: 0, 2, 0

RSSI: 0, 1, 0

CH3: 0, 1, 0

CH4: 0, 1, 0

CH5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)