This is the latest recevied telemetry packets stored in our database for station/object SQ9OE. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
TX*
RX*
Digi*
V_Bat*
V_Ext*
1775042199
23 Count
45 Count
29 Count
0 VDC
0 VDC
1775042197
23 Count
45 Count
29 Count
0 VDC
0 VDC
1775042183
23 Count
45 Count
29 Count
0 VDC
0 VDC
1775041800
16 Count
38 Count
22 Count
0 VDC
0 VDC
1775041743
15 Count
37 Count
21 Count
0 VDC
0 VDC
1775041650
12 Count
33 Count
18 Count
0 VDC
0 VDC
1775041183
4 Count
21 Count
10 Count
0 VDC
0 VDC
1775041176
4 Count
19 Count
10 Count
0 VDC
0 VDC
1775040931
0 Count
10 Count
6 Count
0 VDC
0 VDC
*Used Equation Coefficients:
TX: 0, 1, 0
RX: 0, 1, 0
Digi: 0, 1, 0
V_Bat: 0, 0.01, 0
V_Ext: 0, 0.02, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)