SQ9OE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9OE-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1775278971	32 Count	417 Count	32 Count
1775277171	31 Count	396 Count	31 Count
1775275370	26 Count	376 Count	26 Count
1775273570	25 Count	358 Count	25 Count
1775271770	24 Count	335 Count	24 Count
1775269970	23 Count	311 Count	23 Count
1775268171	23 Count	294 Count	23 Count
1775266371	23 Count	282 Count	23 Count
1775264570	23 Count	264 Count	23 Count
1775262770	22 Count	246 Count	22 Count
1775260970	21 Count	226 Count	21 Count
1775259170	21 Count	210 Count	21 Count
1775257370	20 Count	196 Count	20 Count
1775255570	20 Count	175 Count	20 Count
1775253770	17 Count	154 Count	17 Count
1775251970	16 Count	137 Count	16 Count
1775250170	16 Count	125 Count	16 Count
1775248370	16 Count	111 Count	16 Count
1775246570	16 Count	103 Count	16 Count
1775244770	15 Count	91 Count	15 Count
1775242970	14 Count	82 Count	14 Count
1775241170	14 Count	82 Count	14 Count
1775239370	14 Count	82 Count	14 Count
1775237570	13 Count	74 Count	13 Count
1775235770	10 Count	70 Count	10 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)