OE5XFK-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE5XFK-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1788677453	0 C deg	27.8 C deg
1788675638	0 C deg	27.6 C deg
1788673826	0 C deg	27.6 C deg
1788672010	0 C deg	27.7 C deg
1788670192	0 C deg	27.8 C deg
1788668380	0 C deg	27.8 C deg
1788666566	0 C deg	27.8 C deg
1788664750	0 C deg	27.5 C deg
1788662935	0 C deg	27.8 C deg
1788661116	0 C deg	28.1 C deg
1788659306	0 C deg	28.4 C deg
1788657490	0 C deg	28.8 C deg
1788655672	0 C deg	28.3 C deg
1788653857	0 C deg	28.4 C deg
1788652042	0 C deg	28.9 C deg
1788650226	0 C deg	29 C deg
1788648414	0 C deg	28.8 C deg
1788646621	0 C deg	29.2 C deg
1788644786	0 C deg	29.2 C deg
1788642968	0 C deg	29.1 C deg
1788641154	0 C deg	28.6 C deg
1788639338	0 C deg	28.8 C deg
1788637523	0 C deg	28.6 C deg
1788635708	0 C deg	28.2 C deg
1788633895	0 C deg	27.9 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)