K9TWL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object K9TWL-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784711067	320 Count	245 Count	245 Count
1784709264	317 Count	243 Count	243 Count
1784707461	314 Count	241 Count	241 Count
1784705658	311 Count	239 Count	239 Count
1784703890	308 Count	237 Count	237 Count
1784702087	305 Count	235 Count	235 Count
1784700284	302 Count	233 Count	233 Count
1784698481	297 Count	229 Count	229 Count
1784696678	294 Count	227 Count	227 Count
1784694875	291 Count	225 Count	225 Count
1784693072	288 Count	223 Count	223 Count
1784691269	285 Count	221 Count	221 Count
1784689466	280 Count	217 Count	217 Count
1784687663	270 Count	208 Count	208 Count
1784685860	265 Count	204 Count	204 Count
1784684057	257 Count	197 Count	197 Count
1784682290	252 Count	193 Count	193 Count
1784680487	249 Count	191 Count	191 Count
1784678684	244 Count	187 Count	187 Count
1784676881	240 Count	184 Count	184 Count
1784675078	237 Count	182 Count	182 Count
1784673275	233 Count	179 Count	179 Count
1784671472	230 Count	177 Count	177 Count
1784669669	227 Count	175 Count	175 Count
1784667866	224 Count	173 Count	173 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)