SQ8IPQ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8IPQ-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1784777127	161 Count	118 Count
1784775326	160 Count	117 Count
1784773526	159 Count	116 Count
1784771725	158 Count	115 Count
1784769924	157 Count	114 Count
1784768123	156 Count	113 Count
1784766330	155 Count	113 Count
1784764529	154 Count	112 Count
1784760928	152 Count	110 Count
1784759127	151 Count	109 Count
1784757326	150 Count	108 Count
1784755526	149 Count	107 Count
1784753725	148 Count	106 Count
1784751924	147 Count	105 Count
1784750132	146 Count	104 Count
1784748322	145 Count	103 Count
1784746521	144 Count	102 Count
1784744740	143 Count	102 Count
1784742939	142 Count	101 Count
1784741138	141 Count	100 Count
1784739337	140 Count	99 Count
1784737536	139 Count	98 Count
1784735736	138 Count	97 Count
1784733935	137 Count	96 Count
1784732134	136 Count	95 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)