This is the latest recevied telemetry packets stored in our database for station/object DO7DAD-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
Press*
Temp.in*
Hum*
QNH*
Temp.out*
1776635130
1009.7 hPa
7.1 C deg
83.5 %
1023.1 hPa
0 C deg
1776633315
1009.7 hPa
7.3 C deg
84.1 %
1023.2 hPa
0 C deg
1776631755
1009.6 hPa
7.5 C deg
81 %
1023.1 hPa
0 C deg
1776631499
1009.6 hPa
8.1 C deg
77.7 %
1023 hPa
0 C deg
1776631297
1009.7 hPa
8.3 C deg
77.6 %
1023.1 hPa
0 C deg
1776630320
1009.2 hPa
27 C deg
82 %
1021.8 hPa
0 C deg
1776630135
1009.6 hPa
8.2 C deg
77.8 %
1023 hPa
0 C deg
1776629482
1009.6 hPa
8.3 C deg
77.7 %
1023 hPa
0 C deg
1776629395
1009.6 hPa
8.3 C deg
77.7 %
1023 hPa
0 C deg
1776628862
1009.6 hPa
8.4 C deg
76.8 %
1023 hPa
0 C deg
1776626722
1009.4 hPa
9.2 C deg
73.9 %
1022.8 hPa
0 C deg
1776624907
1009.2 hPa
9.6 C deg
73.6 %
1022.6 hPa
0 C deg
*Used Equation Coefficients:
Press: 0, 1, 0
Temp.in: 0, 1, 0
Hum: 0, 1, 0
QNH: 0, 1, 0
Temp.out: 0, 1, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)