LW2DQC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DQC-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780876617	793 Count	2 Count	2 Count
1780874854	792 Count	2 Count	2 Count
1780873050	791 Count	2 Count	2 Count
1780871246	790 Count	2 Count	2 Count
1780869443	789 Count	2 Count	2 Count
1780867639	788 Count	2 Count	2 Count
1780865836	787 Count	2 Count	2 Count
1780864032	786 Count	2 Count	2 Count
1780862229	785 Count	2 Count	2 Count
1780860425	784 Count	2 Count	2 Count
1780858622	783 Count	2 Count	2 Count
1780856818	782 Count	2 Count	2 Count
1780855015	781 Count	2 Count	2 Count
1780853253	780 Count	2 Count	2 Count
1780851450	779 Count	2 Count	2 Count
1780849646	778 Count	2 Count	2 Count
1780847843	777 Count	2 Count	2 Count
1780846039	776 Count	2 Count	2 Count
1780844236	775 Count	2 Count	2 Count
1780842432	774 Count	2 Count	2 Count
1780840628	773 Count	2 Count	2 Count
1780838825	772 Count	2 Count	2 Count
1780837021	771 Count	2 Count	2 Count
1780835218	770 Count	2 Count	2 Count
1780833415	769 Count	2 Count	2 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)