DB0NPR-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DB0NPR-5. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1776635156	386 Count	336 Count
1776633351	385 Count	336 Count
1776631547	384 Count	336 Count
1776629740	383 Count	336 Count
1776627935	382 Count	336 Count
1776626130	381 Count	336 Count
1776624324	380 Count	336 Count
1776622519	379 Count	336 Count
1776620714	378 Count	336 Count
1776618910	377 Count	336 Count
1776617103	376 Count	336 Count
1776615298	375 Count	336 Count
1776613493	374 Count	321 Count
1776611688	373 Count	320 Count
1776609883	372 Count	320 Count
1776608077	371 Count	320 Count
1776588699	360 Count	311 Count
1776586894	359 Count	311 Count
1776585089	358 Count	311 Count
1776583284	357 Count	311 Count
1776581479	356 Count	311 Count
1776579673	355 Count	311 Count
1776577868	354 Count	311 Count
1776576063	353 Count	311 Count
1776574509	352 Count	311 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)