EA7HQG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA7HQG-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788660891	261 Count	843 Count	218 Count
1788659088	253 Count	823 Count	211 Count
1788657285	247 Count	800 Count	206 Count
1788655481	239 Count	780 Count	199 Count
1788653678	232 Count	759 Count	193 Count
1788651875	224 Count	738 Count	186 Count
1788650071	218 Count	713 Count	181 Count
1788648268	211 Count	689 Count	175 Count
1788646465	205 Count	667 Count	170 Count
1788644661	196 Count	644 Count	162 Count
1788642858	188 Count	621 Count	155 Count
1788641054	183 Count	601 Count	151 Count
1788640684	181 Count	598 Count	150 Count
1788640487	179 Count	597 Count	149 Count
1788639664	178 Count	595 Count	149 Count
1788637861	172 Count	576 Count	144 Count
1788636057	162 Count	552 Count	137 Count
1788634254	155 Count	530 Count	131 Count
1788632451	149 Count	513 Count	126 Count
1788630648	143 Count	491 Count	121 Count
1788628845	138 Count	474 Count	117 Count
1788627041	131 Count	452 Count	111 Count
1788625238	126 Count	438 Count	107 Count
1788623435	118 Count	415 Count	100 Count
1788621632	111 Count	393 Count	94 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)