SP8SOB-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8SOB-4. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1776655756	946 Count	935 Count	765 Count
1776654855	941 Count	930 Count	761 Count
1776653970	936 Count	925 Count	757 Count
1776653070	931 Count	920 Count	753 Count
1776652169	927 Count	916 Count	750 Count
1776651268	918 Count	907 Count	742 Count
1776650368	913 Count	902 Count	738 Count
1776649467	908 Count	897 Count	734 Count
1776648566	903 Count	892 Count	730 Count
1776647665	898 Count	887 Count	726 Count
1776646765	893 Count	882 Count	722 Count
1776645864	886 Count	875 Count	716 Count
1776644963	882 Count	871 Count	713 Count
1776644062	877 Count	866 Count	709 Count
1776643162	872 Count	861 Count	705 Count
1776642261	867 Count	856 Count	701 Count
1776641360	862 Count	851 Count	697 Count
1776640459	857 Count	846 Count	693 Count
1776639559	852 Count	841 Count	689 Count
1776638658	847 Count	836 Count	685 Count
1776637757	842 Count	831 Count	681 Count
1776636856	837 Count	827 Count	677 Count
1776635956	832 Count	823 Count	673 Count
1776635055	827 Count	819 Count	669 Count
1776634154	820 Count	812 Count	663 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)