IU5MGF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU5MGF-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1775464691	46 Count	236 Count	6 Count
1775464570	45 Count	236 Count	6 Count
1775464560	45 Count	236 Count	6 Count
1775463568	44 Count	236 Count	6 Count
1775463487	43 Count	236 Count	6 Count
1775462765	42 Count	236 Count	6 Count
1775413673	41 Count	236 Count	6 Count
1775411870	38 Count	221 Count	4 Count
1775410067	35 Count	205 Count	2 Count
1775408044	34 Count	205 Count	2 Count
1775406241	33 Count	205 Count	2 Count
1775402815	32 Count	205 Count	2 Count
1775401012	31 Count	205 Count	2 Count
1775399209	30 Count	205 Count	2 Count
1775397406	29 Count	205 Count	2 Count
1775395603	28 Count	205 Count	2 Count
1775393800	27 Count	205 Count	2 Count
1775391997	26 Count	205 Count	2 Count
1775390194	25 Count	205 Count	2 Count
1775386588	23 Count	205 Count	2 Count
1775384785	22 Count	205 Count	2 Count
1775382982	21 Count	205 Count	2 Count
1775381179	20 Count	205 Count	2 Count
1775379376	19 Count	205 Count	2 Count
1775377573	18 Count	205 Count	2 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)