DL1KDA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL1KDA-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780882103	36 Count	58 Count	25 Count
1780880298	31 Count	50 Count	21 Count
1780878494	29 Count	45 Count	20 Count
1780876690	27 Count	42 Count	19 Count
1780874886	24 Count	39 Count	17 Count
1780873081	19 Count	33 Count	13 Count
1780871277	18 Count	32 Count	13 Count
1780869473	17 Count	30 Count	13 Count
1780867715	10 Count	18 Count	7 Count
1780865911	8 Count	16 Count	6 Count
1780864107	6 Count	13 Count	5 Count
1780862302	2 Count	6 Count	2 Count
1780860498	582 Count	1001 Count	452 Count
1780858694	580 Count	999 Count	451 Count
1780856889	575 Count	983 Count	447 Count
1780855085	574 Count	983 Count	447 Count
1780853281	570 Count	979 Count	444 Count
1780851477	562 Count	967 Count	437 Count
1780849673	560 Count	965 Count	436 Count
1780847868	559 Count	965 Count	436 Count
1780846115	557 Count	962 Count	435 Count
1780844311	556 Count	962 Count	435 Count
1780842507	553 Count	958 Count	433 Count
1780840702	548 Count	942 Count	429 Count
1780838898	545 Count	936 Count	427 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)