MB7ULR Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7ULR. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789788998	239 Count	633 Count	170 Count
1789788098	237 Count	631 Count	169 Count
1789787197	235 Count	629 Count	168 Count
1789786296	233 Count	627 Count	167 Count
1789785396	231 Count	626 Count	166 Count
1789784495	229 Count	623 Count	165 Count
1789783594	226 Count	620 Count	163 Count
1789782694	225 Count	619 Count	163 Count
1789781793	222 Count	616 Count	161 Count
1789780892	221 Count	615 Count	161 Count
1789779091	216 Count	609 Count	158 Count
1789778191	214 Count	607 Count	157 Count
1789777290	212 Count	604 Count	156 Count
1789776389	210 Count	602 Count	155 Count
1789775488	208 Count	600 Count	154 Count
1789774588	205 Count	597 Count	152 Count
1789773687	204 Count	597 Count	152 Count
1789772786	201 Count	593 Count	150 Count
1789771886	200 Count	592 Count	150 Count
1789770985	197 Count	589 Count	148 Count
1789770084	195 Count	587 Count	147 Count
1789769184	193 Count	585 Count	146 Count
1789768283	191 Count	582 Count	145 Count
1789767382	189 Count	580 Count	144 Count
1789766482	187 Count	577 Count	143 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)