OK0DV-0 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0DV-0. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1784698442	116	100	78	170	74
1784692742	116	100	78	170	74
1784692442	114	100	78	170	74
1784689748	116	102	78	170	74
1784684043	118	102	80	166	76
1784674140	118	104	82	160	78
1784672940	118	104	80	162	78
1784671140	118	104	82	160	78
1784669340	120	106	82	160	80
1784655541	124	114	86	158	82
1784651942	128	120	88	158	84
1784649246	132	114	98	138	86
1784638443	130	126	90	154	86
1784504348	116	102	78	190	74
1784498642	118	106	80	190	78
1784497742	118	106	80	192	78
1784487551	126	118	86	186	82
1784481250	136	118	102	162	88
1784479749	134	140	102	158	86
1784478847	132	136	100	162	84
1784478542	130	134	98	166	84
1784474340	122	120	84	190	80
1784473742	122	106	84	188	80
1784473141	120	106	82	190	80
1784469541	118	102	80	192	78

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)