M9NSZ-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M9NSZ-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1787577561	36 Count	705 Count
1787575791	35 Count	685 Count
1787573988	34 Count	665 Count
1787572185	33 Count	651 Count
1787570382	32 Count	636 Count
1787568579	31 Count	621 Count
1787566776	30 Count	605 Count
1787564973	29 Count	590 Count
1787563170	28 Count	569 Count
1787561367	27 Count	548 Count
1787559564	26 Count	521 Count
1787557761	25 Count	503 Count
1787555958	24 Count	481 Count
1787554195	23 Count	462 Count
1787552391	22 Count	445 Count
1787550588	21 Count	421 Count
1787548785	20 Count	401 Count
1787546982	19 Count	380 Count
1787545179	18 Count	357 Count
1787543376	17 Count	338 Count
1787541573	16 Count	316 Count
1787539769	15 Count	296 Count
1787537966	14 Count	276 Count
1787536163	13 Count	259 Count
1787534360	12 Count	240 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)