YO8TVD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YO8TVD-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780551902	164 Count	202 Count	126 Count
1780551123	163 Count	202 Count	126 Count
1780549320	162 Count	202 Count	126 Count
1780547517	161 Count	202 Count	126 Count
1780524928	160 Count	202 Count	126 Count
1780523125	157 Count	200 Count	124 Count
1780521336	156 Count	200 Count	124 Count
1780519536	155 Count	200 Count	124 Count
1780517736	154 Count	200 Count	124 Count
1780515936	153 Count	200 Count	124 Count
1780514136	152 Count	200 Count	124 Count
1780512335	151 Count	200 Count	124 Count
1780510535	150 Count	200 Count	124 Count
1780508735	149 Count	200 Count	124 Count
1780506935	148 Count	200 Count	124 Count
1780505135	147 Count	200 Count	124 Count
1780503332	145 Count	199 Count	123 Count
1780501529	142 Count	197 Count	121 Count
1780486006	141 Count	197 Count	121 Count
1780482436	136 Count	194 Count	118 Count
1780480633	116 Count	175 Count	99 Count
1780478830	106 Count	166 Count	90 Count
1780477027	103 Count	164 Count	88 Count
1780475224	100 Count	162 Count	86 Count
1780473421	86 Count	73 Count	73 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)