IU5RCJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU5RCJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780147067	121 Count	84 Count	18 Count
1780146164	108 Count	80 Count	16 Count
1780145260	96 Count	48 Count	15 Count
1780144356	82 Count	34 Count	13 Count
1780143452	68 Count	27 Count	12 Count
1780142549	54 Count	20 Count	9 Count
1780141645	42 Count	16 Count	7 Count
1780140741	27 Count	9 Count	4 Count
1780139837	13 Count	4 Count	2 Count
1780138933	1009 Count	461 Count	217 Count
1780138029	997 Count	455 Count	215 Count
1780137125	980 Count	447 Count	213 Count
1780136221	969 Count	443 Count	211 Count
1780135317	947 Count	436 Count	209 Count
1780134412	937 Count	423 Count	207 Count
1780133509	914 Count	409 Count	206 Count
1780132605	904 Count	405 Count	204 Count
1780131702	883 Count	394 Count	201 Count
1780130798	871 Count	390 Count	199 Count
1780129989	849 Count	380 Count	196 Count
1780129086	835 Count	375 Count	194 Count
1780128182	822 Count	365 Count	191 Count
1780127275	807 Count	358 Count	189 Count
1780126371	793 Count	351 Count	188 Count
1780125468	781 Count	346 Count	187 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)