DK8VW-55 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DK8VW-55. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1788604406	0 C deg	22.9 C deg
1788602591	0 C deg	22.5 C deg
1788600776	0 C deg	22.1 C deg
1788598961	0 C deg	21.5 C deg
1788597146	0 C deg	20.8 C deg
1788595331	0 C deg	19.8 C deg
1788593516	0 C deg	19.2 C deg
1788591701	0 C deg	18.9 C deg
1788589886	0 C deg	18.4 C deg
1788588071	0 C deg	17.4 C deg
1788586256	0 C deg	16.9 C deg
1788584441	0 C deg	16.7 C deg
1788582626	0 C deg	17.1 C deg
1788580811	0 C deg	17.8 C deg
1788578996	0 C deg	18.4 C deg
1788577181	0 C deg	18.6 C deg
1788575366	0 C deg	18.8 C deg
1788573551	0 C deg	19 C deg
1788571736	0 C deg	19.4 C deg
1788569921	0 C deg	19.7 C deg
1788568106	0 C deg	20.1 C deg
1788566291	0 C deg	20.4 C deg
1788564476	0 C deg	21 C deg
1788562660	0 C deg	21.4 C deg
1788560846	0 C deg	21.8 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)