SQ7HIL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7HIL-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1781417596	418 Count	595 Count	131 Count
1781417533	417 Count	595 Count	131 Count
1781417469	416 Count	594 Count	131 Count
1781417406	415 Count	594 Count	131 Count
1781417343	414 Count	594 Count	131 Count
1781417279	413 Count	594 Count	131 Count
1781417216	412 Count	594 Count	131 Count
1781417153	411 Count	594 Count	131 Count
1781417090	410 Count	594 Count	131 Count
1781417027	409 Count	594 Count	131 Count
1781416963	408 Count	594 Count	131 Count
1781416899	407 Count	594 Count	131 Count
1781416836	406 Count	594 Count	131 Count
1781416773	405 Count	594 Count	131 Count
1781416710	404 Count	594 Count	131 Count
1781416647	403 Count	594 Count	131 Count
1781416583	402 Count	593 Count	131 Count
1781416520	401 Count	593 Count	131 Count
1781416457	400 Count	593 Count	131 Count
1781416394	399 Count	593 Count	131 Count
1781416331	398 Count	593 Count	131 Count
1781416267	397 Count	593 Count	131 Count
1781416204	396 Count	593 Count	131 Count
1781416141	395 Count	593 Count	131 Count
1781416078	394 Count	593 Count	131 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)