M9PHD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M9PHD-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780574235	12 Count	0 Count	0 Count
1780573635	11 Count	0 Count	0 Count
1780573033	10 Count	0 Count	0 Count
1780572433	9 Count	0 Count	0 Count
1780571832	8 Count	0 Count	0 Count
1780571231	7 Count	0 Count	0 Count
1780570631	6 Count	0 Count	0 Count
1780570030	5 Count	0 Count	0 Count
1780569429	4 Count	0 Count	0 Count
1780568829	3 Count	0 Count	0 Count
1780568228	2 Count	0 Count	0 Count
1780567627	1 Count	0 Count	0 Count
1780567027	0 Count	0 Count	0 Count
1780566426	1000 Count	853 Count	439 Count
1780565825	999 Count	853 Count	439 Count
1780565225	998 Count	853 Count	439 Count
1780564624	997 Count	853 Count	439 Count
1780564023	996 Count	853 Count	439 Count
1780563422	995 Count	853 Count	439 Count
1780562822	994 Count	853 Count	439 Count
1780562221	993 Count	853 Count	439 Count
1780561621	992 Count	853 Count	439 Count
1780561020	991 Count	853 Count	439 Count
1780560419	990 Count	853 Count	439 Count
1780559818	989 Count	853 Count	439 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)