M6MTR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M6MTR-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780487716	67 Count	64 Count	32 Count
1780487115	65 Count	62 Count	31 Count
1780486514	63 Count	60 Count	30 Count
1780485914	61 Count	58 Count	29 Count
1780485314	59 Count	56 Count	28 Count
1780484712	57 Count	54 Count	27 Count
1780484237	55 Count	52 Count	26 Count
1780483511	53 Count	50 Count	25 Count
1780482910	51 Count	48 Count	24 Count
1780482309	49 Count	46 Count	23 Count
1780481709	47 Count	44 Count	22 Count
1780481108	45 Count	42 Count	21 Count
1780480507	43 Count	40 Count	20 Count
1780479907	41 Count	38 Count	19 Count
1780479306	39 Count	36 Count	18 Count
1780478705	37 Count	34 Count	17 Count
1780478105	35 Count	32 Count	16 Count
1780477504	33 Count	30 Count	15 Count
1780476903	31 Count	28 Count	14 Count
1780476303	29 Count	26 Count	13 Count
1780475702	27 Count	24 Count	12 Count
1780475101	25 Count	22 Count	11 Count
1780473924	17 Count	18 Count	9 Count
1780473323	15 Count	16 Count	8 Count
1780472723	13 Count	14 Count	7 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)