SQ7FSO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7FSO-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1780445338	124 Count	119 Count	117 Count
1780443722	122 Count	117 Count	115 Count
1780441921	120 Count	115 Count	113 Count
1780440121	118 Count	113 Count	111 Count
1780438321	116 Count	111 Count	109 Count
1780436521	107 Count	102 Count	100 Count
1780434721	107 Count	102 Count	100 Count
1780432316	107 Count	102 Count	100 Count
1780430516	107 Count	102 Count	100 Count
1780428715	106 Count	101 Count	99 Count
1780426915	104 Count	99 Count	97 Count
1780425115	102 Count	97 Count	95 Count
1780423315	100 Count	95 Count	93 Count
1780421515	98 Count	93 Count	91 Count
1780419715	96 Count	91 Count	89 Count
1780417915	94 Count	89 Count	87 Count
1780416114	92 Count	87 Count	85 Count
1780414314	90 Count	85 Count	83 Count
1780412514	88 Count	83 Count	81 Count
1780395470	88 Count	83 Count	81 Count
1780393670	86 Count	81 Count	79 Count
1780391870	84 Count	79 Count	77 Count
1780390070	82 Count	77 Count	75 Count
1780388269	79 Count	74 Count	72 Count
1780386469	75 Count	70 Count	68 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)