SV3SMG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV3SMG-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	V_Bat*
1781409048	314 Count	4.09 VDC
1781407244	312 Count	4.08 VDC
1781405441	309 Count	4.09 VDC
1781403638	307 Count	4.09 VDC
1781401834	304 Count	4.08 VDC
1781400031	302 Count	4.06 VDC
1781398227	299 Count	4.07 VDC
1781396465	297 Count	4.09 VDC
1781394662	295 Count	4.09 VDC
1781392858	293 Count	4.09 VDC
1781391055	290 Count	4.08 VDC
1781389251	288 Count	4.09 VDC
1781387448	286 Count	4.09 VDC
1781385645	284 Count	4.09 VDC
1781383841	282 Count	4.07 VDC
1781382038	280 Count	4.07 VDC
1781380234	277 Count	4.07 VDC
1781378431	275 Count	4.05 VDC
1781376627	273 Count	4.08 VDC
1781374919	272 Count	4.08 VDC
1781373285	271 Count	4.08 VDC
1781371482	269 Count	4.08 VDC
1781369678	266 Count	4.07 VDC
1781367875	264 Count	4.09 VDC
1781366113	262 Count	4.07 VDC

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)