EA9ABY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA9ABY-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	V_Bat*
1787648622	180 Count	3.41 VDC
1787647718	179 Count	3.42 VDC
1787646814	178 Count	3.42 VDC
1787645910	177 Count	3.42 VDC
1787645007	176 Count	3.41 VDC
1787644103	175 Count	3.42 VDC
1787643199	174 Count	3.42 VDC
1787642295	173 Count	3.41 VDC
1787641392	172 Count	3.42 VDC
1787640488	171 Count	3.42 VDC
1787639584	170 Count	3.41 VDC
1787638680	169 Count	3.42 VDC
1787637776	168 Count	3.42 VDC
1787636873	167 Count	3.42 VDC
1787635969	166 Count	3.42 VDC
1787635065	165 Count	3.42 VDC
1787634161	164 Count	3.43 VDC
1787633258	163 Count	3.43 VDC
1787632354	162 Count	3.43 VDC
1787631450	161 Count	3.43 VDC
1787630547	160 Count	3.43 VDC
1787629643	159 Count	3.44 VDC
1787628739	158 Count	3.44 VDC
1787627835	157 Count	3.43 VDC
1787626932	156 Count	3.44 VDC

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)