SQ9WRT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9WRT-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787571017	262 Count	48 Count	44 Count
1787570858	261 Count	48 Count	44 Count
1787570415	260 Count	48 Count	44 Count
1787570114	259 Count	48 Count	44 Count
1787569813	258 Count	48 Count	44 Count
1787569512	256 Count	48 Count	44 Count
1787569211	254 Count	47 Count	43 Count
1787568910	253 Count	47 Count	43 Count
1787568609	252 Count	47 Count	43 Count
1787568308	250 Count	45 Count	42 Count
1787568007	249 Count	44 Count	42 Count
1787567705	248 Count	44 Count	42 Count
1787567404	246 Count	43 Count	41 Count
1787567102	245 Count	43 Count	41 Count
1787566881	244 Count	42 Count	41 Count
1787566580	241 Count	40 Count	39 Count
1787566419	240 Count	40 Count	39 Count
1787565978	239 Count	40 Count	39 Count
1787565677	236 Count	39 Count	38 Count
1787565376	235 Count	39 Count	38 Count
1787565075	234 Count	39 Count	38 Count
1787564774	233 Count	39 Count	38 Count
1787564473	232 Count	39 Count	38 Count
1787564172	231 Count	39 Count	38 Count
1787563871	229 Count	38 Count	37 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)