KC7HES-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KC7HES-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787605588	571 Count	258 Count	13 Count
1787603788	499 Count	229 Count	11 Count
1787601987	416 Count	189 Count	10 Count
1787600187	331 Count	149 Count	7 Count
1787598387	258 Count	114 Count	5 Count
1787596586	177 Count	79 Count	3 Count
1787594786	109 Count	52 Count	2 Count
1787592986	1023 Count	514 Count	22 Count
1787591185	953 Count	470 Count	19 Count
1787589385	874 Count	422 Count	16 Count
1787587585	789 Count	386 Count	14 Count
1787585784	694 Count	340 Count	12 Count
1787583988	585 Count	298 Count	10 Count
1787582187	517 Count	275 Count	9 Count
1787580387	445 Count	253 Count	9 Count
1787578586	347 Count	186 Count	7 Count
1787576786	275 Count	140 Count	6 Count
1787574986	202 Count	114 Count	5 Count
1787573185	144 Count	95 Count	5 Count
1787571385	68 Count	50 Count	2 Count
1787569585	1002 Count	561 Count	32 Count
1787567784	932 Count	521 Count	29 Count
1787565984	865 Count	472 Count	27 Count
1787564184	789 Count	433 Count	24 Count
1787562386	721 Count	418 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)