IK3YPW-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IK3YPW-14. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Volt*	Ampere*
1788559184	13.7 V	-1 A
1788557371	13.8 V	-1 A
1788555554	13.8 V	-1 A
1788553739	13.7 V	-1 A
1788551924	13.8 V	-1 A
1788550110	13.7 V	-1 A
1788548292	13.7 V	-1 A
1788546477	13.7 V	-1 A
1788544665	13.8 V	-1 A
1788542849	13.8 V	-1 A
1788541034	13.8 V	-1 A
1788537403	13.8 V	-1 A
1788535589	13.8 V	-1 A
1788530142	13.7 V	-1 A
1788526515	13.8 V	-1 A
1788524696	13.8 V	-1 A
1788519254	13.8 V	-1 A
1788517439	13.8 V	-1 A
1788515623	13.8 V	-1 A
1788513806	13.8 V	-1 A
1788511991	13.8 V	-1 A
1788510182	13.8 V	-1 A
1788508363	13.8 V	-1 A
1788506547	13.7 V	-1 A
1788504730	13.8 V	-1 A

*Used Equation Coefficients:

Volt: 0, 1, 0

Ampere: 0, 1, 0

Batt: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)