This is the latest recevied telemetry packets stored in our database for station/object W1FN-6. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
Vin*
Rx1h*
Dg1h*
Eff1h*
DgR1h*
1782010323
13.8 Volt
410 Pkt
190 Pkt
74 Pcnt
45783 Pct
1782008523
13.88 Volt
210 Pkt
90 Pkt
72 Pcnt
42924 Pct
1782006783
13.65 Volt
10 Pkt
0 Pkt
76 Pcnt
23076 Pct
1782006170
13.88 Volt
380 Pkt
180 Pkt
68 Pcnt
46529 Pct
1782004370
14.25 Volt
200 Pkt
90 Pkt
70 Pcnt
47263 Pct
1782002630
14.25 Volt
0 Pkt
0 Pkt
69 Pcnt
33333 Pct
*Used Equation Coefficients:
Vin: 0, 0.075, 0
Rx1h: 0, 10, 0
Dg1h: 0, 10, 0
Eff1h: 0, 1, 0
DgR1h: 0, 1, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)