SQ7I-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7I-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784693172	23 Count	501 Count	21 Count
1784691372	21 Count	411 Count	19 Count
1784689571	20 Count	340 Count	18 Count
1784687771	18 Count	275 Count	16 Count
1784685971	16 Count	207 Count	14 Count
1784684171	13 Count	143 Count	11 Count
1784682371	9 Count	89 Count	7 Count
1784680571	6 Count	38 Count	4 Count
1784678771	0 Count	0 Count	0 Count
1784676972	378 Count	962 Count	296 Count
1784675172	375 Count	933 Count	294 Count
1784673372	372 Count	894 Count	292 Count
1784671571	370 Count	868 Count	291 Count
1784669771	369 Count	867 Count	291 Count
1784667971	369 Count	866 Count	291 Count
1784666171	367 Count	865 Count	291 Count
1784664371	367 Count	864 Count	291 Count
1784662571	365 Count	863 Count	291 Count
1784660771	365 Count	862 Count	291 Count
1784658971	364 Count	861 Count	291 Count
1784657170	363 Count	860 Count	291 Count
1784655372	362 Count	858 Count	290 Count
1784653572	359 Count	856 Count	289 Count
1784651771	359 Count	855 Count	289 Count
1784649971	356 Count	853 Count	288 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)