DA6CH-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DA6CH-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1782509265	25 Count	54 Count
1782507462	24 Count	53 Count
1782505659	23 Count	52 Count
1782503909	22 Count	52 Count
1782502053	21 Count	52 Count
1782501414	20 Count	52 Count
1782499814	19 Count	52 Count
1782494671	17 Count	48 Count
1782492918	16 Count	48 Count
1782491064	15 Count	47 Count
1782489261	14 Count	32 Count
1782487458	13 Count	32 Count
1782485655	12 Count	31 Count
1782483852	11 Count	29 Count
1782482049	10 Count	25 Count
1782480246	9 Count	22 Count
1782478443	8 Count	3 Count
1782478297	7 Count	3 Count
1782477927	6 Count	0 Count
1782477703	5 Count	0 Count
1782477690	4 Count	0 Count
1782477555	3 Count	0 Count
1782477501	2 Count	0 Count
1782477371	1 Count	0 Count
1782477004	0 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)