SR9WXS-0 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9WXS-0. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1784685260	108	8	7	0	100
1784664918	65	6	4	0	100
1784650399	131	19	17	2	100
1784649199	145	23	21	0	100
1784611104	110	5	4	0	100
1784603927	124	9	8	0	100
1784603327	92	7	5	0	100
1784601842	92	7	5	0	100
1784598613	108	5	4	0	100
1784594061	81	7	6	1	100
1784587125	102	7	6	1	100
1784585925	108	9	7	2	100
1784547952	115	5	4	0	100
1784537007	76	5	4	1	100
1784523017	98	11	10	0	100
1784521813	125	11	10	0	100
1784519549	98	7	5	0	100
1784514096	92	9	7	0	100
1784505014	89	11	9	0	100
1784503211	102	9	7	0	100
1784497114	84	7	6	0	100
1784496514	86	9	8	0	100
1784483604	82	8	6	0	100
1784481801	91	14	12	1	100
1784472659	75	4	2	0	100

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)