M0BPQ-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M0BPQ-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Rx1h*	Eff1h*
1772651691	0 Pkt	100 Pcnt
1772651392	0 Pkt	100 Pcnt
1772651091	0 Pkt	100 Pcnt
1772650792	0 Pkt	100 Pcnt
1772650490	0 Pkt	100 Pcnt
1772650190	0 Pkt	100 Pcnt
1772649890	0 Pkt	100 Pcnt
1772649613	0 Pkt	100 Pcnt
1772649289	0 Pkt	100 Pcnt
1772648989	0 Pkt	100 Pcnt
1772648688	0 Pkt	100 Pcnt
1772648388	0 Pkt	100 Pcnt
1772648088	0 Pkt	100 Pcnt
1772647788	0 Pkt	0 Pcnt
1772647487	0 Pkt	50 Pcnt
1772647187	0 Pkt	33 Pcnt
1772646887	0 Pkt	14 Pcnt
1772646586	0 Pkt	41 Pcnt
1772646286	0 Pkt	46 Pcnt
1772645986	10 Pkt	52 Pcnt
1772645686	10 Pkt	60 Pcnt
1772645401	10 Pkt	55 Pcnt
1772645085	10 Pkt	56 Pcnt
1772644786	10 Pkt	54 Pcnt
1772644484	10 Pkt	54 Pcnt

*Used Equation Coefficients:

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A4: 0, 0, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)