KM4FBJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KM4FBJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1784690536	81 Count	36 Count	36 Count
1784688735	80 Count	36 Count	36 Count
1784686934	79 Count	36 Count	36 Count
1784685133	78 Count	36 Count	36 Count
1784683332	77 Count	36 Count	36 Count
1784681531	76 Count	36 Count	36 Count
1784679730	75 Count	36 Count	36 Count
1784677944	74 Count	36 Count	36 Count
1784676143	73 Count	36 Count	36 Count
1784674342	72 Count	36 Count	36 Count
1784672541	71 Count	36 Count	36 Count
1784670740	70 Count	36 Count	36 Count
1784668939	69 Count	36 Count	36 Count
1784667138	68 Count	36 Count	36 Count
1784665337	67 Count	36 Count	36 Count
1784663536	66 Count	36 Count	36 Count
1784661735	65 Count	36 Count	36 Count
1784659934	61 Count	33 Count	33 Count
1784658133	49 Count	22 Count	22 Count
1784658029	47 Count	22 Count	22 Count
1783884936	46 Count	22 Count	22 Count
1783884901	45 Count	22 Count	22 Count
1783884714	44 Count	22 Count	22 Count
1783884660	43 Count	22 Count	22 Count
1783873323	42 Count	22 Count	22 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)