SP6RSP-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RSP-4. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784688495	45 Count	221 Count	28 Count
1784687894	35 Count	176 Count	22 Count
1784687293	28 Count	147 Count	18 Count
1784686693	19 Count	92 Count	13 Count
1784686092	8 Count	42 Count	6 Count
1784685491	214 Count	1019 Count	134 Count
1784684890	204 Count	977 Count	128 Count
1784684289	194 Count	936 Count	122 Count
1784683689	187 Count	901 Count	118 Count
1784683088	178 Count	848 Count	113 Count
1784682487	168 Count	811 Count	107 Count
1784681886	161 Count	768 Count	103 Count
1784681286	152 Count	725 Count	98 Count
1784680685	133 Count	656 Count	83 Count
1784680084	126 Count	599 Count	79 Count
1784679483	111 Count	534 Count	68 Count
1784678882	98 Count	490 Count	59 Count
1784678282	90 Count	437 Count	54 Count
1784677681	84 Count	394 Count	52 Count
1784677080	75 Count	357 Count	47 Count
1784676479	68 Count	323 Count	43 Count
1784675879	55 Count	256 Count	34 Count
1784675278	40 Count	213 Count	23 Count
1784674677	33 Count	181 Count	19 Count
1784674076	24 Count	132 Count	14 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)