PU3ZJM-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PU3ZJM-15. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Vin*	Temp*
1761506745	11.1 Volt	26 C
1761485146	11.18 Volt	23.5 C
1761463547	11.25 Volt	24 C
1761441947	11.18 Volt	27.5 C
1761390368	11.85 Volt	24 C
1761384803	11.25 Volt	24 C
1761363204	11.33 Volt	28.5 C
1761324767	13.13 Volt	31.5 C
1761315016	11.78 Volt	28 C
1761293417	11.85 Volt	23 C
1761271817	11.93 Volt	27.5 C
1761250218	12 Volt	36.5 C
1761217424	12.83 Volt	21.5 C
1761208484	10.8 Volt	21 C
1761186885	11.03 Volt	25.5 C
1761154479	12 Volt	30.5 C
1761144180	11.03 Volt	27 C
1761122581	11.1 Volt	20.5 C
1761100982	11.25 Volt	26.5 C
1761066104	12.83 Volt	27 C
1761053769	11.7 Volt	22 C
1760701367	11.4 Volt	25 C
1760691862	10.95 Volt	21 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Temp: 0, 0.5, -64

A3: 0, 0, 0

A4: 0, 0, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)