SP8C-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8C-14. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1787590407	286 Count	841 Count
1787589504	285 Count	817 Count
1787588602	284 Count	794 Count
1787587698	283 Count	769 Count
1787585655	282 Count	769 Count
1787584825	281 Count	769 Count
1787583922	280 Count	769 Count
1787583019	279 Count	769 Count
1787582116	278 Count	759 Count
1787581213	277 Count	739 Count
1787580309	276 Count	732 Count
1787579406	275 Count	732 Count
1787578503	274 Count	732 Count
1787577600	273 Count	732 Count
1787576697	272 Count	732 Count
1787575794	271 Count	732 Count
1787574891	270 Count	732 Count
1787573988	269 Count	732 Count
1787573085	268 Count	732 Count
1787572182	267 Count	732 Count
1787571279	266 Count	732 Count
1787570376	265 Count	732 Count
1787569473	264 Count	732 Count
1787568569	263 Count	732 Count
1787567666	262 Count	732 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)