SP1WLQ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1WLQ-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789934596	969 Count	52 Count	52 Count
1789934475	968 Count	52 Count	52 Count
1789934354	967 Count	52 Count	52 Count
1789934234	966 Count	52 Count	52 Count
1789934113	965 Count	52 Count	52 Count
1789933992	964 Count	52 Count	52 Count
1789933872	963 Count	52 Count	52 Count
1789933751	962 Count	52 Count	52 Count
1789933631	961 Count	52 Count	52 Count
1789933510	960 Count	52 Count	52 Count
1789933389	959 Count	52 Count	52 Count
1789933268	958 Count	52 Count	52 Count
1789933148	957 Count	52 Count	52 Count
1789933027	956 Count	52 Count	52 Count
1789932907	955 Count	52 Count	52 Count
1789932786	954 Count	52 Count	52 Count
1789932665	953 Count	52 Count	52 Count
1789932545	952 Count	52 Count	52 Count
1789932424	951 Count	52 Count	52 Count
1789932303	950 Count	52 Count	52 Count
1789932183	949 Count	52 Count	52 Count
1789932072	948 Count	52 Count	52 Count
1789931941	947 Count	52 Count	52 Count
1789931820	946 Count	52 Count	52 Count
1789931699	945 Count	52 Count	52 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)