This is the latest recevied telemetry packets stored in our database for station/object DD8BA-13. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
Press*
Temp.in*
Hum*
QNH*
Temp.out*
1789958595
1022.7 hPa
25.6 C deg
0 %
1027.1 hPa
0 C deg
1789956775
1022.7 hPa
25.7 C deg
0 %
1027.1 hPa
0 C deg
1789954938
1022.7 hPa
25.7 C deg
0 %
1027.1 hPa
0 C deg
1789953134
1022.8 hPa
25.8 C deg
0 %
1027.2 hPa
0 C deg
1789947611
1022.8 hPa
25.9 C deg
0 %
1027.2 hPa
0 C deg
1789945783
1022.8 hPa
25.9 C deg
0 %
1027.2 hPa
0 C deg
1789934800
1021.7 hPa
26.4 C deg
0 %
1026.1 hPa
0 C deg
1789932972
1021.5 hPa
26.2 C deg
0 %
1025.9 hPa
0 C deg
1789911011
1016 hPa
26.8 C deg
0 %
1020.4 hPa
0 C deg
1789905053
1015.1 hPa
26.3 C deg
0 %
1019.5 hPa
0 C deg
1789903234
1014.8 hPa
26.6 C deg
0 %
1019.2 hPa
0 C deg
*Used Equation Coefficients:
Press: 0, 1, 0
Temp.in: 0, 1, 0
Hum: 0, 1, 0
QNH: 0, 1, 0
Temp.out: 0, 1, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)