JA2YQQ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object JA2YQQ-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1787586656	142	183	255	82	57
1787584854	142	183	255	82	57
1787583953	142	183	255	82	57
1787583052	142	183	255	82	57
1787582151	142	183	255	82	57
1787581250	142	183	255	82	57
1787580349	142	183	255	82	57
1787579448	142	183	255	81	56
1787578547	142	183	255	81	56
1787577646	142	183	255	81	56
1787576745	142	183	255	81	56
1787575844	142	183	255	81	56
1787574943	142	183	255	81	56
1787574042	142	183	255	81	56
1787573141	142	183	255	81	56
1787572240	142	183	255	81	56
1787571339	142	183	255	81	56
1787570438	142	184	255	81	57
1787569537	142	184	255	81	57
1787568636	142	184	255	80	57
1787567735	142	184	255	80	56
1787566834	142	184	255	80	57
1787565933	142	184	255	80	57
1787565032	142	184	255	80	55
1787564131	142	184	255	80	55

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)