SP9RNS-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9RNS-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787568529	625 Count	3 Count	3 Count
1787567628	624 Count	3 Count	3 Count
1787566727	623 Count	3 Count	3 Count
1787565827	622 Count	3 Count	3 Count
1787564925	621 Count	3 Count	3 Count
1787564024	620 Count	3 Count	3 Count
1787563123	619 Count	3 Count	3 Count
1787562223	618 Count	3 Count	3 Count
1787561322	617 Count	3 Count	3 Count
1787560421	616 Count	3 Count	3 Count
1787559544	615 Count	3 Count	3 Count
1787558643	614 Count	3 Count	3 Count
1787557742	613 Count	3 Count	3 Count
1787556841	612 Count	3 Count	3 Count
1787555940	611 Count	3 Count	3 Count
1787555039	610 Count	3 Count	3 Count
1787554138	609 Count	3 Count	3 Count
1787553241	608 Count	3 Count	3 Count
1787552336	607 Count	3 Count	3 Count
1787551436	606 Count	3 Count	3 Count
1787549637	604 Count	3 Count	3 Count
1787548733	603 Count	3 Count	3 Count
1787547832	602 Count	3 Count	3 Count
1787546932	601 Count	3 Count	3 Count
1787546031	600 Count	3 Count	3 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)