SQ9LCJ Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9LCJ. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787567473	467 Count	20 Count	20 Count
1787565672	465 Count	20 Count	20 Count
1787563877	464 Count	20 Count	20 Count
1787562077	463 Count	20 Count	20 Count
1787560276	461 Count	20 Count	20 Count
1787558475	460 Count	20 Count	20 Count
1787556674	458 Count	20 Count	20 Count
1787554874	457 Count	20 Count	20 Count
1787553073	455 Count	20 Count	20 Count
1787551272	454 Count	20 Count	20 Count
1787549471	453 Count	20 Count	20 Count
1787547670	451 Count	20 Count	20 Count
1787545870	450 Count	20 Count	20 Count
1787544069	448 Count	20 Count	20 Count
1787542277	447 Count	20 Count	20 Count
1787540476	445 Count	20 Count	20 Count
1787538675	444 Count	20 Count	20 Count
1787536960	442 Count	20 Count	20 Count
1787535074	441 Count	20 Count	20 Count
1787533273	440 Count	20 Count	20 Count
1787531472	438 Count	20 Count	20 Count
1787529672	437 Count	20 Count	20 Count
1787527871	435 Count	20 Count	20 Count
1787526070	434 Count	20 Count	20 Count
1787524269	432 Count	20 Count	20 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)