SP4SAS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4SAS-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787572329	451 Count	842 Count	374 Count
1787571428	434 Count	818 Count	358 Count
1787570528	429 Count	807 Count	354 Count
1787569627	424 Count	799 Count	350 Count
1787568726	414 Count	782 Count	341 Count
1787567825	410 Count	775 Count	338 Count
1787566940	400 Count	760 Count	333 Count
1787566040	396 Count	752 Count	330 Count
1787565139	387 Count	736 Count	322 Count
1787564238	382 Count	725 Count	318 Count
1787563338	376 Count	714 Count	313 Count
1787562437	371 Count	704 Count	309 Count
1787561536	365 Count	694 Count	304 Count
1787560636	361 Count	687 Count	301 Count
1787559735	355 Count	678 Count	296 Count
1787558834	349 Count	667 Count	291 Count
1787557933	342 Count	656 Count	285 Count
1787556132	330 Count	633 Count	275 Count
1787555231	324 Count	623 Count	270 Count
1787554330	318 Count	612 Count	265 Count
1787553430	307 Count	594 Count	255 Count
1787552529	298 Count	576 Count	247 Count
1787551628	294 Count	566 Count	244 Count
1787550728	289 Count	555 Count	240 Count
1787549827	284 Count	545 Count	236 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)