This is the latest recevied telemetry packets stored in our database for station/object WY7W-0. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
Vin*
Rx1h*
Dg1h*
Eff1h*
A5*
1787543367
188 Volt
26 Pkt
7 Pkt
90 Pcnt
0 None
1787528968
188 Volt
52 Pkt
8 Pkt
94 Pcnt
0 None
1787176177
187 Volt
58 Pkt
9 Pkt
86 Pcnt
0 None
1787161778
188 Volt
64 Pkt
11 Pkt
92 Pcnt
0 None
*Used Equation Coefficients:
Vin: 0, 1, 0
Rx1h: 0, 1, 0
Dg1h: 0, 1, 0
Eff1h: 0, 1, 0
A5: 0, 1, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)