DN9DJE-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DN9DJE-9. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	V_Ext*
1787513808	14 Count	0 VDC
1787512908	14 Count	0 VDC
1787512008	14 Count	0 VDC
1787511108	14 Count	0 VDC
1787510208	14 Count	0 VDC
1787509308	14 Count	0 VDC
1787509209	14 Count	0 VDC
1787509079	14 Count	0 VDC
1787509066	14 Count	0 VDC
1787509050	14 Count	0 VDC
1787508921	14 Count	0 VDC
1787508856	14 Count	0 VDC
1787508792	14 Count	0 VDC
1787508711	14 Count	0 VDC
1787508674	13 Count	0 VDC
1787508497	12 Count	0 VDC
1787508427	11 Count	0.08 VDC
1787508399	10 Count	0.08 VDC
1787508349	9 Count	0.08 VDC
1787508315	8 Count	0.08 VDC
1787508273	7 Count	0.08 VDC
1787508220	6 Count	0.08 VDC
1787508181	1 Count	0.08 VDC
1787508157	0 Count	0.08 VDC
1787508072	0 Count	0.08 VDC

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)