IU0VBE-7 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU0VBE-7. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787588420	631 Count	610 Count	156 Count
1787586617	630 Count	609 Count	156 Count
1787584814	627 Count	603 Count	154 Count
1787583011	625 Count	600 Count	153 Count
1787581207	623 Count	597 Count	152 Count
1787579404	620 Count	593 Count	150 Count
1787577601	619 Count	593 Count	150 Count
1787575798	618 Count	593 Count	150 Count
1787573995	617 Count	593 Count	150 Count
1787572192	616 Count	593 Count	150 Count
1787570389	615 Count	593 Count	150 Count
1787568623	614 Count	593 Count	150 Count
1787566820	613 Count	593 Count	150 Count
1787565017	612 Count	593 Count	150 Count
1787563214	611 Count	593 Count	150 Count
1787561411	610 Count	593 Count	150 Count
1787559607	609 Count	593 Count	150 Count
1787557804	608 Count	593 Count	150 Count
1787556001	607 Count	593 Count	150 Count
1787554198	606 Count	593 Count	150 Count
1787552395	605 Count	593 Count	150 Count
1787550592	604 Count	593 Count	150 Count
1787548789	603 Count	593 Count	150 Count
1787547022	602 Count	593 Count	150 Count
1787545219	601 Count	593 Count	150 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)