DL8GAK-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL8GAK-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Celsius*	Rel_Hum*	Atm_Press*
1787506677	33.8	29	1022.25
1787506653	33.8	29	1023
1787505593	34.2	30.4	1024.25
1787505308	34.3	29.9	1025
1787505244	34.3	29.53	1024.63
1787505217	34.3	30.17	1021.63
1787505112	34.3	30.06	1024.63
1787505064	34.3	29.75	1023.38
1787505040	34.3	29.75	1024.38
1787504360	34.9	30.37	1021.88
1787504263	34.9	29.65	1023.25
1787504228	34.9	29.5	1022.63
1787503878	35	30.63	1022.38
1787502974	35.2	29.87	1022.75
1787502070	35.3	30.03	1022.88
1787501166	35.4	30.19	1023.5
1787500262	35.3	31.4	1023.38
1787499358	35.2	31.25	1023.13
1787498286	35.6	31.72	1023.25
1787498228	35.6	31.75	1023
1787498174	35.6	32.04	1023
1787498126	35.6	32.28	1023.5
1787497896	35.6	32.46	1023.13
1787497822	35.5	32.6	1022.63
1787497798	35.5	32.6	1022

*Used Equation Coefficients:

Celsius: 0, 0.1, -50

Rel_Hum: 0, 0.01, 0

Atm_Press: 0, 0.125, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)