EB5BZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5BZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1788570782	3 Count	416 Count
1788569630	2 Count	350 Count
1788567586	1 Count	223 Count
1788565541	0 Count	110 Count
1788563496	8 Count	1054 Count
1788561451	7 Count	951 Count
1788559406	6 Count	850 Count
1788557361	5 Count	725 Count
1788555316	4 Count	598 Count
1788553271	3 Count	482 Count
1788551226	2 Count	366 Count
1788549181	1 Count	241 Count
1788548031	0 Count	153 Count
1788545987	6 Count	1052 Count
1788543942	5 Count	908 Count
1788541897	4 Count	761 Count
1788539851	3 Count	631 Count
1788537806	2 Count	483 Count
1788535762	1 Count	323 Count
1788533717	0 Count	166 Count
1788531672	6 Count	1034 Count
1788529626	5 Count	891 Count
1788527581	4 Count	774 Count
1788526430	3 Count	675 Count
1788524385	2 Count	485 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)